Question 1

What is the best 9,000 BTU air conditioner?

Accepted Answer

The best 9,000 BTU air conditioner we list is the Senville Leto 9,000 BTU Mini Split Heat Pump 115V, a single split that covers up to 400 sq ft at 38 dB(A), in stock at Sylvane for $739. For sizing, ENERGY STAR's chart recommends 9,000 BTU for a room of 350 to 400 sq ft.

Question 2

What size room does a 9,000 BTU air conditioner cool?

Accepted Answer

About 350 to 400 sq ft. ENERGY STAR's room air conditioner sizing chart recommends 9,000 BTU for a room of 350 to 400 sq ft; a room of 300 to 350 sq ft needs only 8,000 BTU, and one of 400 to 450 sq ft calls for 10,000 BTU. The chart assumes an ordinary room: add 10% for a very sunny room, take 10% off for a heavily shaded one, add 600 BTU for each person beyond two who is regularly in it, add 4,000 BTU for a kitchen, and size up for a ceiling above about 8 feet. The compare.ac size calculator applies all of these to your room. A portable is the exception: most state their size on the older ASHRAE scale, and the Department of Energy's SACC rating for the same unit, lower and closer to what it delivers in a room, is the one to size by. Of the 2 portables here, one has a known SACC, rated 5,500 BTU SACC, which the same chart matches to rooms of about 100 to 150 sq ft. Each model on this page also shows the room its own maker or listing states, which can differ from the chart.

Question 3

How many watts does a 9,000 BTU air conditioner use?

Accepted Answer

9,000 BTU mini-splits (at their rating point, from their EER2) draw a middle 720 W (from 584 W to 918 W), about 13¢ an hour at full power. These are the middle figures of the models we list at this size that state their draw; once the room is cool the compressor cycles, so most hours draw less.

Question 4

How much cooling power do I need for my room?

Accepted Answer

A common US rule of thumb for a standard, reasonably insulated room with an 8-foot ceiling is about 20 BTU per hour per square foot, so a 300 sq ft room is often quoted around 6,000 BTU and a 500 sq ft room around 10,000 BTU. compare.ac instead sizes against the official ENERGY STAR room air conditioner chart, which is not a flat rate: it recommends about 7,000 BTU for that same 300 sq ft room and about 12,000 BTU for a 500 sq ft room, then adjusts up for a hot or humid climate and down for a mild one once you pick your region. Add capacity for a sunny west-facing or top-floor room, a kitchen, or extra people who are regularly in it. Undersizing means the unit runs flat out and never cools; oversizing short-cycles and leaves the room cool but clammy.

Question 5

Does my climate change how much cooling I need?

Accepted Answer

Yes, more than almost anything except the size of the room. compare.ac's base sizing, before any climate adjustment, follows the official ENERGY STAR room air conditioner chart, which assumes a temperate summer. A hot, dry region like Arizona, or a hot, humid one like Florida and the Texas Gulf coast, realistically needs on the order of 20 to 30 percent more cooling per square foot, because the outdoor design temperature is higher and, in humid places, the unit also spends energy removing moisture (the latent load). A mild, marine climate such as the Pacific Northwest or coastal New England needs a little less. compare.ac applies this adjustment once you pick your region in the tool, using ASHRAE Standard 169 design temperatures and ACCA Manual-J regional sizing practice, and always shows both your real room size and the adjusted figure it sizes against. For a final purchase, a professional Manual-J load calculation for your specific home is the accurate method.

Question 6

What will it cost to run, and what do the efficiency ratings mean?

Accepted Answer

Running cost is driven by efficiency: CEER on window and portable units, and SEER2 on mini-splits. Higher is better on both, but they are separate scales and a SEER2 number cannot be read as a ratio against a CEER number. Directionally, an efficient inverter mini-split is the cheapest type to run, while a single-hose portable can cost roughly two to three times as much for the same comfort, because much of its capacity is lost back through the exhaust hose. For window and portable units that ENERGY STAR certifies, we go a step further and show an estimated dollars-per-year figure, taken from the model's published annual energy use (a DOE test that assumes about 750 hours of cooling a year) priced at the average US residential electricity rate. It is a standardized figure for comparing units, not a personal bill: your real cost depends on how much you run it, your local electricity rate, and your climate. Mini-splits are usually the most efficient of all but are rated on SEER2, so we do not convert those to a dollar figure, and a missing running cost is a data gap, never a sign a unit is worse.

Question 7

How much noise is acceptable?

Accepted Answer

Noise is measured in dB(A). A quiet split indoor unit on a low setting can be around 19 to 25 dB(A), which is barely audible and fine for a bedroom. Around 30 to 35 dB(A) is a soft hum that most people accept in a living room. Portable monobloc units are usually 52 to 58 dB(A) because the compressor sits in the room with you, which is closer to a dishwasher and can disturb sleep. If quiet matters, a split almost always wins; if you only cool occasionally, a portable may be acceptable.

What is the best 9,000 BTU air conditioner?

Our top 6 picks

Every 9,000 BTU air conditioner, by type

9,000 BTU mini-splits

9,000 BTU portable air conditioners

9,000 BTU PTAC units

How we chose

Frequently asked

More buying guides